The steel chain belt stays steady and handles heavy scrap metal with ease

The motor drives the shaft directly for higher efficiency

Linked to the PLC panel, the belt speed adjusts to the hammer mill’s workload

Rugged cutter shafts are shielded by HARDOX 500 wear plates

After the crushing chamber is welded it undergoes full stress-relief annealing, then is finish-machined and bored on CNC equipment to ensure reliable long-term service under heavy load

Built-in sensors spot uncrushable objects and tell the crusher to eject them automatically

The screen runs on rails. Loosen eight screws, pull it out with a forklift, and swap screens in about two minutes

A hydraulic pack lets you change hammers and pins quickly and safely

Special springs under the crusher greatly cut operating vibration

Use vibration to disperse the hammer mill’s final product

Feed the material evenly into the next drum magnetic separator

Separate the steel from the end products

Separates metal from non-metal materials

Eccentric magnetic pole design keeps separation rate and output high

Automatic pulse dust system efficiently captures dust across the entire line